Larry Mitchell

Serial Encoder General Information Serial encoders are encoders which provide the position count and/or other information (such as error detection bits, overheat bits, etc.) as a serial data stream...

Generic brush type permanent magnet motors can be run using the TI-3000JX system. There is no setup entry required to run them. Since they are brush motors, there is no feedback type to be selected...

Overview Quadrature pulse encoders generate an A and B pulse which are 90 degrees out of phase with each other. These encoders are usually used with external counting circuitry which counts either ...

Overview Resolver feedback is a special case. Rather than try to categorize or list as manufacturers all the various resolver setups, resolvers are listed simply as a generic type.   Setup The FBK ...

The TI-5000JX provides limited support for Parallel Absolute Encoders. Parallel Absolute encoders are functionally similar to many serial encoders because they maintain an absolute position rather ...

Generic Pulse feedback is a special case. Rather than try to categorize or list all the various manufacturers of Hall effect motors, Hall effect feedback motors are simply listed as a generic type....

The TI-5000JX provides support for resolver check out with built-in resolver hardware (no external adapter module required). The resolver may be connected directly to the TI-5000JX resolver connect...

Overview AB Series F, H, N, S, and Y use Renco incremental encoders, so please see that section for details. These motors may also be Reliance or Electrocraft brand depending upon their age. Refer ...

Generic Encoder feedback is a special case. Rather than try to categorize or list all the manufacturers of various incremental encoder setups, incremental encoders are simply listed as a generic ty...

The Generic Brush, Generic Resolver, Generic Pulse, and Generic Encoder selections allow you to run a wide variety of motors using very basic feedback types. While the Heidenhain Endat encoders are...