Robinio Easley

The AMC B25A20AC, B30A40AC, B40A40AC, B60A40AC, and B100A400AC provide dipswitch settings for various amplifier configurations. It is recommended that you start with the following settings when bei...

See Section 2.6.6.1 in the Training Manual for complete Kawasaki Motor and Serial Encoder details. There are several models of Kawasaki serial encoders, and two are currently supported by the TI-50...

There have been a lot of great developments going on at Mitchell Electronics Inc. The TI-5000EX and TI-3000 units that you are used to have been replaced by the newer TI-5000JX and TI-3000JX series...

Whenever our customers experience technical difficulties, our main priorities are to get you up and running and determine what happened to potentially prevent repeat issues. For our technical staff...

  We have over 300 different test cables which are tested in our automated fixture before shipment so the pinout is guaranteed to be correct. The tester warranty is valid and product support is off...

Introduction There are a few pieces of test equipment available that could be used to test certain feedback devices, however, none of these devices are truly focused on alignment of the feedback to...

Q: Once I start the checkout, does the time run continuously, or can I stop the tester and restart it later?A: The Credit Platform provides 30 minutes of continuous use on either the TI-5000JX or ...

The legacy TI-5000EX units that do not have 64 bit USB drivers means you will need the following RS232 and USB adapter cables and drivers installed to use your legacy tester on an updated Windows 7...

  In Microsoft 365 organizations with mailboxes in Exchange Online or standalone Exchange Online Protection (EOP) organizations without Exchange Online mailboxes, quarantine holds potentially dange...

Most VPL series motors will use our TI-5734 cable and TI-5106 module to test with the DSL software. The motor data is stored in the memory including the alignment needed. If you already have the ca...