Robinio-Easley

GENERAL DESCRIPTION Perform these simple steps to determine if your TI-5000JX resolver hardware is in need of inspection. You will need the TI-3011 resolver breakout board and two clip leads to com...

The following items have been updated in this newest software release. Athena 5.1.0.2262New Encoder Selections Yaskawa serial 24-bit ABS (SIGMA 7) Fanuc Serial High Speed Beta A1000i, Pulsecod...

Introduction There are a few pieces of test equipment available that could be used to test certain feedback devices, however, none of these devices are truly focused on alignment of the feedback to...

The B&R 8LS series motors are starting to come equipped with a hybrid power/feedback connector. These motor models can be identified by these feedback types in their model code: S0, S1, S2, S3, etc...

Rexroth's newest motors are the MS2N series. As you can see from the model info below, they can come equipped with legacy Hiperface SKS/SKM and SEK/SEL encoder options, or they can come with the ne...

    Motor/Feedback Description – The Fanuc SL series motors appear to have the same feedback and same alignment as the Panasonic MSM motors, so in this discussion we will not distinguish one from t...

These motors have an integrated drive on top. As with most motors with integrated drives, we do not support testing through the drive portion. However, you can remove the drive and get down to the...

We specialize in testing and aligning feedbacks and we don't have much expertise in other types of motor testing. Below are a few simple suggestions.    Most motors will have a torque rating on the...

    Mitsubishi commonly uses a 10 pin DDK connector for their servo motors. There are two main wiring setups that can be used with these connectors, each requiring a different test cable. If you ar...

It is important to be connected to the motor's UVW power leads in the correct phase order, or else the feedback alignment will not be correct. To confirm the correct connections, perform the motor ...